Wednesday, December 22, 2010

using mold base become locking block of slider unit

moldbase sometimes can be used for the locking block on the slider unit, this is basedon several reasons, for example, to reduce cost, by reducing the insert locking block, the other reason is required surface area for the locking block.



illustration picture above shows the angular pins are bolted to the mold base and the mold base made pocket instead of locking block,

to keep the process easy to do maintenance, should be installed oil slide plate, so when it can wear easily replaced without the need to change their plate slider block.
This model is widely used for large parts and molds with a tonnage greater than 350 tons, other advantage is the size of the mold base to be more compact and small, so the cost for the mold base can also be reduced, and if the size is smaller base can mold into tonnase also smaller

4 comments:

How can we analyse injection moul machine based on production rate and other things to prepare a simple project like file.....
will you please guide me in steps what to do

have you read selection of injection mold book?
this book will guide you to prepare project like file or proposal to built select right injection mold

Ready made mould base, any size, or mould accessories ready stock available. contact Asad +92-333-4325141

I completely agree with the points you have discussed in the blog. nice share and thank you so much for sharing it with us. looking for more.